The XM Torch 2M industrial vacuum cleaner is the ideal solution for extracting fumes directly from the welding torch. This vacuum cleaner from Depureco's welding fumes range is equipped with one / two powerful By-Pass motors that guarantee up to 190 m3 / h of airflow each. The industrial vacuum is controlled directly by the welding machine. A sophisticated sensor positioned on the vacuum allows detecting when there is a flow of current in the ground cable located in the special clip. Depureco's XM Torch 2Mindustrial vacuum cleaner is equipped with a cellulose filter that allows you to filter welding fumes in total safety. On request, it is also possible to install an H14 filter.
SUCTION UNIT
The vacuum is generated by 2 by-pass motors. Each motor is managed by an independent switch, permitting the operator to control the intake performance. The motors are located in a sturdy casing, with an insulating sponge to maintain a low noise level.
FILTERING ELEMENT
The filtration is guaranteed by a sturdy polyester filtering cartridge. The cartridge is made to ensure large filter surface (40.000 cm2) in a compact space. This way air can pass through when the filter is dirty too. The filter is M Class (BIA | EN 60335-2-69) certified. It stops the particles till 1 micron, preserving the motors and the operator.
Jet Clean® FILTER CLEANING SYSTEM
The vacuum cleaner is equipped whit a new filter cleaning system named JetClean® designed by Depureco. Using the difference in pressure outside and inside the vacuum cleaner, the system generates an air jet which by travelling through the cartridge detaches the dust from the filter's surface. It is a fast and efficient way to keep the filter clean during operations, without stopping the vacuuming operations.
REMOTE CONTROL
A sensor installed on one side of the unit enables the operator to control the machine directly from the welding unit. Passing the cable in the clip will make it so that when the welding starts the vacuum cleaner will start at the same time.
INDUSTRIAL VACUUM XM TORCH 2M |
Technical data
Motor
Type
By-Pass
Voltage
230
V
Maximum vacuum
250
mBar
Maximum air flow
380
m3/h
Noise level
72
dB(A)
Engines
2
Frequency
50/60
Hz
Power
3,5
HP
Primary Filter
Type
cartridge
Diameter
305
mm
Class EN 60335-2-69
M Class
Media
polyester PTFE
Filter cleaning
Jet Clean
Filtering efficiency (IFA)
IFABGIA M-PES AL
Machine
Suction inlet
40
Ø mm
Dimensions
534 x 471
mm
Height
983
mm
Weight
38
Kg
INDUSTRIAL VACUUM XM TORCH 2M |
Options
AVAILABLE FILTER MEDIA
ACB
Active carbon filter
HEPA 14
Absolute filter (EN 1822)
22.000 cm² filter surface H14 Class Filter (EN 1822) Glass fiber
STRUCTURE AND OPTIONS
BX
Stainless steel bin AISI 304
GRD
Grounding
INDUSTRIAL VACUUM XM TORCH 2M |
Accessories
P12349
Starter kit Ø 40mm
Basic kit containing specific accessories for 40 mm diameter solids and liquids vacuuming
P12302
Reduction rubber sleeve for “EVA” hose Ø 50/40mm
Antistatic carbon-filled rubber sleeve for 50/40 mm diameter EVA flexible hose
P12000
Suction hood (400x50mm)
Galvanised steel suction hood for welding fumes or suspended dusts. Connection for 50mm diameter pipe with bracket and magnet for positioning it
P12350
Starter kit Ø 50mm
Basic kit containing specific accessories for 50 mm diameter solids and liquids vacuuming
